Last modified 30 May 2008 by Bob Burchsted
Photos are courtesy of Andrew Dickinson at Jamestown Boat Yard
The rig needed a little work - the spreader tip cups were jammed. Actually, this did not work - they ended up using heat to remove the spreader tip cups.
They have put the teak planks back on.
The refrigeration pump needed a little work. This picture and the next shows the accumulator, which has a pin hole.
The new accumulator, and the old one.
The refrigeration pallet.
The interior bulkhead has been put back together. This shot is from the refrigerator side.
This shot is from the pilot berth side.
